USB charging without fear
MSP432E401Y: USB Device; Pull Up Resistors needed? - MSP low-power microcontroller forum - MSP low-power microcontrollers - TI E2E support forums
USB in a NutShell - Chapter 2 - Hardware
![Resolved] Resistors on USB - necessary? - Other Hardware Development - Arduino Forum](https://aws1.discourse-cdn.com/arduino/original/4X/5/e/0/5e0a71f891b87d1427afe8e022a3144604fe47a4.png "Resolved] Resistors on USB - necessary? - Other Hardware Development - Arduino Forum")
Resolved] Resistors on USB - necessary? - Other Hardware Development - Arduino Forum
ON Semiconductor Is Now
Does the resistor value on D+ and D- line matter on Arduinos? - Electrical Engineering Stack Exchange
USB Type A Female Breakout Hookup Guide - learn.sparkfun.com
To what voltage should the D+ line be pulled up when designing USB connection in STM32? +5V or +3.3V? All documentation and dev board scematics says it's 3.3V, but it didn't work.
Does the resistor value on D+ and D- line matter on Arduinos? - Electrical Engineering Stack Exchange
Modify a Cheap USB Charger to Feed an IPod, IPhone or Samsung Galaxy : 7 Steps (with Pictures) - Instructables
Configuring a micro-controller for low-speed USB communication
Eric Bylenga :: Welcome
Why "drive USB pull-up resistor to '0' to disable USB"? - Troubleshooting Help - TinyFPGA
USB dedicated charging port (DCP) controller BL2513M
The Mystery of USB Chargers | Electronics Repair And Technology News
Are these USB series resistors important?
The Basics of USB Battery Charging | Maxim Integrated
Is it okay/safe to short a Micro USB's data pins (D+, D-, ID)? : r/ECE
ftdi - What is the purpose of capacitors and resistors in this USB bus? - Electrical Engineering Stack Exchange
The Mystery of USB Chargers | Electronics Repair And Technology News
A brief introduction to the USB protocol - AVR
USB Back Voltage
